![]() So the problem seems to be not with what's going into the VUMT, but how the channel strip is reacting to the sound file coming through the VUMT to the channel. But before even trying that, before touching anything, if I look to the channel strip meter, its already pushing into the yellow, way above the -18db. So there would/should be (just from looking at the VUMT) sufficient enough room to increase the VUMT Trim so the needle gets closer to 0. Most of the different drums coming in (with the drum/sound file already set at 0 and the VUMT at Unity) register around -2.5 to -3.0, depending on the dynamics. I can of course raise or lower the gain on the sound file to get the VU closer to 0 on the VUMT. Just to be clear, the drums (any given particular drum/sound file - kick, snare, hi-hat ) that I'm working with are already set 0 gain by default without me adjusting anything. But replace that sine wave with an instrument (a sound file) set 0 gain with the VUMT still on Unity, and things are quite different. So by any account, that is how it should be working. I can't see the problem being with the meter, since a sine wave -18db into the VUMT Unity holds a perfect 0.0db on the VUMT VU meter and -18.0db on the channel strip meter. Tell me what I'm doing wrong and how I can get this thing right. In the end, some adjustment needs to be made so that the VUMT VU is hovering around 0db and the channel strip's meter is hovering around -18db. My question is how do I get these meters to read where they should? It seems to me that the instrument needs to come down (actually reducing the waveform it looks like it might be a rather hot signal), but I don't know where to find its current gain value, let alone how to adjust it. If I then increase the Trim on the VUMT to bring the VU needle up to 0, the channel strip's meter is then way into the red, often pinned a +6.0. "Working optimally" should have the VUMT VU needle hovering -0db. If I bring down the VUMT Trim so that the channel strip is reading at around -18db (where it should be), the VUMT winds up being set so low that it can't possibly be working optimally. Yet, the channel strip meter reads upwards of +2.5 to +3.5, depending on the dynamics. The instrument (in this case, a kick), however, is only reading at about -5.0db on the VUMT VU meter. When I have a recorded instrument track coming in, it first hits a VUMT (with its Trim at 0.0) and the VU needle responds. On the channel strip meter it reads -18db. With the VUMT Trim set at 0.0, the sine wave comes in and the VUMT VU meter reads a steady 0db, which is what the reading should be. I then sent that sine wave into a Klanghelm VUMT, which is calibrated at -18db. In first position on a test channel's plug-in section, I inserted Logic 9's Test Oscillator, selected "sine wave", and set the gain at -18db. The situation described below was being monitored in Pre-Fader mode.ฤก. ![]() I have a problem with setting up my gain staging and getting levels where they should be.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |